Analog Input

As of v1.0 the head tracker software supports two analog inputs on pins A6 and A7 with a 0 to 3.3V range. They can be used for anything you wish but the initial intention was for them to be used as a throttle and rudder input. This will allow you to use this software as a single handed controller. Using roll for aileron and tilt for elevator. Rudder can't use the pan output because if you spin your body the rudder will also change which is why it's using an analog input.

Version 2.1+ supports 4 inputs on A4, A5, A6, A7

Analog input

GUI Settings

For setup in the GUI see page below

Analog