Head Tracker v2.1
  • Head Tracker v2.1
    • HeadTracker v2.2
  • Getting Started
    • Hardware Required
    • Software Installation
      • Flashing Firmware
    • Wiring
      • Option 1- Bluetooth
        • Adding a FrSky BT Module
        • Checking Bluetooth Functionality?
      • Option 2 - Wired
        • Pulse Position Modulation (PPM)
          • Trainer Ports
        • Serial Bus (SBUS)
          • Radio Master TX16S Setup
          • FrSky Taranis X9D
      • Option 3 - Bridged
        • Radio Master TX16S Mk2
      • Analog Input
      • Digital Inputs
      • PPM Input
      • PWM Output
      • ELRS Setup
      • Flight Stick
    • Mounting
      • User Designed Cases
    • Structure of the Application
    • IMU, Calibration and Drift
    • Extended Servo Range
  • Settings
    • GUI Setup
      • Tilt / Roll / Pan
      • General
      • Output
      • Input
      • Bluetooth
      • PWM
      • Analog
      • Aux
  • Radio Setup
    • How to Edit Documentation
    • Open/Edge TX
      • Color Screen Radios
      • Black and White Radios
    • Jeti
    • Spektrum
      • NX
      • DX
        • DX18
    • Flysky
    • Frsky - Ethos
  • Videos
    • YouTube
  • Support
    • Discord Chat
    • Issues
    • Development
      • Firmware
        • Debugging
        • Arduino Nano 33 BLE
        • IMU Sensor Chip
      • GUI (Qt6)
      • GUI (Qt5, Depreciated)
      • Git Workflow and Actions
  • Links
    • Download
    • GitHub Page
    • RC Groups Forum
Powered by GitBook
On this page

Was this helpful?

  1. Getting Started
  2. Wiring

Option 3 - Bridged

Wireless using another Nano 33 BLE as a bridge to your radio

PreviousFrSky Taranis X9DNextRadio Master TX16S Mk2

Last updated 3 years ago

Was this helpful?

The bridge method allows you to remove the wire from your head to your radio by using a second Nano 33 BLE as a receiver board. The receiver will take the incoming Bluetooth and output either SBUS or PPM just like the wired version. You can also put your reset button on this board where it's easy to reach.

You will need to program both units with the same firmware version for best compatibility

See the for setup with a remote board.

Bluetooth GUI Settings Page